How to Clean Merrell Walking Shoes: Step-by-Step Guide
The easiest way to clean Merrell walking shoes is with a soft brush, warm water, and mild soap. Start by removing the laces and insoles, then gently scrub the upper and sole to lift dirt. This simple routine works for most Merrell styles, including leather, suede, and mesh.
We found that regular cleaning keeps your shoes looking fresh and helps them last much longer. Even better, the right method protects the waterproofing and grip that Merrell shoes are known for. You don’t need fancy products—just a little time and the right steps to avoid damaging the materials.
- Remove laces and insoles first so every part gets cleaned and dries properly.
- Use a soft brush or cloth with lukewarm water and mild dish soap.
- Scrub gently in circles to lift dirt without harming the fabric or leather.
- Rinse with a damp cloth—never soak the whole shoe in water.
- Air dry at room temperature away from direct heat or sunlight.
Below, we walk you through the complete cleaning process for every Merrell shoe type, including how to handle tough stains and restore that fresh-off-the-trail look. Let’s get those shoes looking brand new again.
Refreshing Your Merrell Shoes Step by Step
We found that most Merrell shoes clean up well with a simple kit you already own. Grab a soft brush (an old toothbrush works great), a bowl of lukewarm water, and a drop of mild dish soap. That is all you really need to start.
Working from the top down matters. We suggest you handle the uppers first, then the soles, and save the insoles for last. This way, you are not dragging dirt from one part back onto a clean section.
Getting Your Supplies Ready
You do not need fancy shoe cleaners. Many experts say gentle dish soap breaks down trail grime without stripping protective coatings (Consumer Reports). Stay away from bleach or harsh detergents, as they can fade colors and weaken the glue.
Gather these items before you start:
- A soft-bristled brush or clean toothbrush
- Two soft cloths (one for scrubbing, one for rinsing)
- Lukewarm water in a small bowl
- A drop of mild dish soap or a tiny bit of laundry detergent
- White vinegar (for stubborn odors later)
- Newspaper or paper towels for drying
Removing Laces and Insoles the Right Way
Take out the laces completely. This is not just about reaching every eyelet. It also stops the laces from pressing marks into the fabric while the shoes dry.
Slide out the insoles gently. We found that insoles hold the most sweat and odor, so they need their own cleaning pass. If your insoles are removable (most Merrell models are), you can wash them in the sink with soap and water.
Cleaning Methods by Shoe Material
Different Merrell shoes use different fabrics. Leather, suede, and mesh each have their own quirks. Using the wrong method can cause damage, so it helps to know what your pair is made of before you dunk anything in water.
The label inside the tongue usually lists the materials. Check that tag first, then follow the right guide below.
Mesh and Synthetic Uppers
Mesh is the most common material on Merrell trail runners and hikers. It is breathable, but it also traps dust deep in the weave.
Start by brushing loose dirt off the dry shoe. Then dip your brush into the soapy water and scrub in small circles over the mesh. Do not press too hard, or you can stretch the fabric and ruin the fit.
Rinsing Mesh Without Soaking
Use a clean cloth dipped in plain water to wipe away the soap suds. Wring it out well first. You want a damp cloth, not a dripping one, because soaking mesh can break down the glue that holds the shoe together.
We found that working in small panels works best. Clean the toe box, then the sides, then the heel. This keeps the soap from drying before you rinse it off.
Leather and Nubuck Care
Leather Merrells look sharp but need a lighter touch. Submerging leather in water makes it stiff and cracked when it dries.
Use a damp cloth to wipe the surface instead of a brush. For dried mud, let it flake off naturally first. Then gently wipe with the cloth. Leather conditioner is good for smooth leather once a season, but only after the shoe is fully dry.
- Damp cloth only for smooth leather
- Soft brush for nubuck and suede
- No soap on leather unless it is really stained
- Air dry only — heat makes leather shrink
Suede and Nubuck Treatment
Suede is the pickiest material in the Merrell lineup. You almost never want to use water on it. A dry brush is your best friend here.
Brush in one direction to lift the nap and remove surface dirt. For water stains, a white eraser or a suede cleaning stone works well. Many trail experts recommend a suede protector spray after cleaning to keep future stains from sinking in.
Tackling the Soles and Tough Stains
The outsole gets the brunt of the trail. Mud fills in the tread grooves, and it is the first thing people notice when you walk by.
You can be a bit more aggressive here since the rubber is tough. A stiff brush or even an old kitchen scrub pad works fine. Just avoid metal brushes that can gouge the rubber.
A Simple Table for Stain Types
| Stain Type | Solution That Works |
|---|---|
| Mud (wet) | Let it dry, then brush it off |
| Mud (dried) | Scrub with a stiff brush, no water |
| Grass or dirt | Soapy water with a toothbrush |
| Oil or grease | Cornstarch on the spot, let it sit overnight |
| Salt stains | One part water, one part white vinegar |
For salt stains from winter walking, a vinegar and water mix is your safest bet. Dab it on with a cloth and let it dry. The vinegar neutralizes the salt without hurting the fabric, according to cleaning research from the University of Nebraska Extension.
Fighting Odors That Linger
Sweaty feet happen. That smell settles into the insoles and the lining, not just the surface. If you skip the insoles, you will still smell yesterday’s hike tomorrow.
Wash the insoles with soapy water and let them dry completely before putting them back. For extra odor control, sprinkle baking soda inside the shoe overnight. Shake it out in the morning. We found that adds up to fresher shoes with almost zero extra effort.
Drying and Restoring Your Shoes
How you dry your shoes matters just as much as how you clean them. Heat is the enemy here. Never toss Merrell shoes in the dryer or set them near a radiator.
The heat can warp the sole and shrink the upper. You will end up with a shoe that does not fit right anymore, no matter how clean it looks.
The Safe Drying Routine
Stuff the shoes with newspaper or paper towels after cleaning. The paper pulls moisture out from the inside, which speeds things up without heat.
Change the paper once it gets damp. This usually happens after a few hours. Then leave the shoes in a room-temperature spot with good airflow. A fan pointing at them helps a lot.
Avoid direct sunlight on the shoes while they dry. UV rays can fade the color and make synthetic materials brittle. We found that indirect light works perfectly fine and keeps colors vibrant.
Reapplying Waterproofing Spray
Many Merrell shoes come with a waterproof membrane, but washing removes some of the DWR (durable water repellent) coating. Reapplying after a deep clean keeps rain beading off the surface.
Wait until the shoes are 100 percent dry first. Then spray evenly from about six inches away. Let it dry for an hour before wearing. Follow the spray bottle directions, as some formulas need two coats.
Keeping the Fresh Look Longer
You clean them, and then they get dirty again in a week. That is the cycle of walking shoes. But you can slow down the grime buildup with a few simple habits.
Knock your shoes together after each hike to knock off loose dirt. Give them a quick brush pass before you toss them in the closet. Spending 30 seconds now saves you a 20-minute deep clean later.
When to Clean vs When to Replace
Honestly, there is only so much cleaning can do. If the soles are worn flat or the uppers have holes, it is time to shop for a new pair. Research from the American Orthopaedic Foot & Ankle Society suggests replacing athletic shoes every 300 to 500 miles.
Check the tread depth regularly. If you can press a penny into the tread and not see the top of Lincoln’s head, your grip is still good. If not, the shoe has done its job.
Your Quick Cleaning Checklist
- Remove laces and insoles before any cleaning
- Brush off loose dirt while shoes are dry
- Use lukewarm soapy water, not hot or cold
- Scrub gently with a soft brush in circular motions
- Rinse with a damp cloth, never under running water
- Air dry with newspaper, away from heat and sunlight
Keep this list handy, and you will be set for the whole year. Regular care keeps your Merrells comfortable and ready for whatever adventure comes next.
Conclusion
Cleaning your Merrell walking shoes really comes down to two things: gentle care and regular attention. You now have the full game plan, from removing laces and insoles to matching the right scrub for leather, suede, or mesh. Skip the harsh soap, avoid the washing machine, and never let heat near them while they dry. Those simple habits protect the waterproofing, the grip, and the fit.
Your best next step? Take five minutes right now to brush off today’s dirt and spot-check the laces. A small habit today saves you a serious deep clean later. Your shoes will feel better on your feet, and they’ll be ready when you are.
Frequently Asked Questions
Can I put my Merrell shoes in the washing machine?
We strongly recommend against it. The machine’s agitation and spin cycle can weaken the glue that holds the sole and upper together. It can also crush the cushioning in the midsole. You might get a cleaner looking shoe, but it will likely break down faster.
How often should I wash my Merrell walking shoes?
We found that a quick surface brush after every few hikes is enough day-to-day care. Do a full deep clean—soap, water, and drying—every month or after any heavy mud or salt exposure. If you wear them daily, a monthly wash keeps them fresh without wearing out the materials.
What is the best way to dry wet Merrell shoes fast?
Use a towel to press out excess water first, then stuff them with newspaper. Change the paper every few hours as it absorbs moisture. Aim a fan at the shoes, but keep them away from direct heat or sunlight. This usually does the job in under 24 hours.
Should I use soap or just water on my Merrell shoes?
Plain water works for light dust, but you need a drop of mild dish soap to break down grease and ground-in dirt. Avoid heavy detergents or any soap with bleach. Test the soap on a small spot first, especially if your pair is suede or nubuck.
How long do Merrell walking shoes last before you need new ones?
Most walking shoes last around 300 to 500 miles before the cushioning flattens out and the tread wears down. Check the sole for smooth spots and feel for a firm midsole. When the shoe no longer feels supportive underfoot, it is time for a replacement.
